2002 AUDI S4 4DR SEDAN
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition BLK (+) IGNITION SWITCH HARNESS
Starter01 RED/BLK + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BRN/WHT (-) DRIVER'S KICK PANEL BLU PLUG OR ALARM MO
FrontLeftDoorTrigger BRN/YEL DRIVERS KICK PANEL
FrontRightDoorTrigger BRN/WHT PASS KICK PANEL
TrunkTrigger WHT/BLK - (-) ABOVE MOD, FAC ALARM BOTTOM PASS TRUNK
HoodTrigger BRN/YEL - AT HOOD PIN SWITCH
FactoryAlarmDisarm DISARMS WITH UNLOCK
FactoryAlarmArm ARMS WITH LOCK
ParkingLights GRY/BLK GRY (+) HEADLIGHT SWITCH
Security
Parking Lights
ALSO (+) GRAY/RED-DIODE ISOLATE
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition BLK (+) IGNITION SWITCH HARNESS
Ignition02 RED THIN + (+) IGN SWITCH
Ignition03 BLU + SECOND STARTER WIRE MUST USE FOR REMOTE
Accessory01 BLK/YEL + (+) IGNITION SWITCH HARNESS
Starter01 RED/BLK + (+) IGNITION SWITCH HARNESS
AntiTheftType RF ACTIVATED SYS.
AntiTheftSystem TRANSPONDER
Tach GRN/BLU (AC) INSTRUMENT CLUSTER OR ECM DRIVERS FIREWA
SpeedSense WHT/BLU (AC) INS. CLUSTER OR VSS ALSO CRUISE CONTROL
ParkingLights GRY/BLK GRY (+) HEADLIGHT SWITCH
BrakeLights RED/BLK + (+) AT SWITCH
Horn BLK/YEL + HORN RELAY
Doorlocks / Window
PowerUnLock GRY/WHT - (-) DRIVERS KICK PANEL OR ALARM
PowerLock BRN/GRY OR RE (-) DRIVERS KICK PANEL OR ALARM
LeftFrontWindow02 NOT RECOMMENDED
RightFrontWindow01 NOT RECOMMENDED
RightFrontWindow02 NOT RECOMMENDED
LeftRearWindow01 NOT RECOMMENDED
LeftRearWindow02 NOT RECOMMENDED
RightRearWindow01 NOT RECOMMENDED
RightRearWindow02 NOT RECOMMENDED
Convenience
HeadLights YEL OR YEL/RE (+) HEADLIGHT SWITCH
LowSpeedWipers BLK/GRN(L),BL STEERING COLUMN
TrunkRelease YEL/RED + AT SWITCH
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/YEL + (+) IGNITION SWITCH HARNESS
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
